Chamberlain SW 2000-X3 用户手册
37 of 42
Doc 01-20099
Rev F
ADJUSTMENTS
OBSTRUCTION
Adjustable pot controls gate sensitivity to blockages by the
RIGHT (R69)
instantaneous rise in motor current. When the limit is exceeded, the
gate stops and reverses a programmed distance (a minimum of 2
inches).
gate stops and reverses a programmed distance (a minimum of 2
inches).
OBSTRUCTION
Adjustable pot controls gate sensitivity to blockages by the
LEFT (R160)
instantaneous rise in motor current. When the limit is exceeded, the
gate stops and reverses a programmed distance (a minimum of 2
inches).
gate stops and reverses a programmed distance (a minimum of 2
inches).
NOTE: LiftMaster gate operators have two obstruction sense adjustments (left and
right) where other gate operators have only one. This allows greater
flexibility of installation. For instance, you can install a gate on an incline
and not worry about sacrificing downhill gate sensitivity.
flexibility of installation. For instance, you can install a gate on an incline
and not worry about sacrificing downhill gate sensitivity.
INRUSH
Adjustable pot controls the delay in sensitivity to gate
(R203)
obstructions. This delay in sensitivity prevents the initial motor
inrush current from causing a obstruction fault. The weight of the
gate determines this setting.
inrush current from causing a obstruction fault. The weight of the
gate determines this setting.
CONNECTORS
LIMIT SWITCH (J4)
Connector for the left/right limit switch cable.
PWR INPUT (J1)
Connector for AC input power.
MOTOR POWER (J3) Connector for the motor cable.
LOOP DETECTOR
Connector for the optional LiftMaster Outside Interrupt Loop
detector
detector
(J15) add-on
board.
LOOP DETECTOR
Connector for the optional LiftMaster Inside Interrupt Loop detector
(J12) add-on
board.
LOOP DETECTOR
Connector for optional LiftMaster Shadow Loop detector add-on
(J13) board.
LOOP DETECTOR
Connector for optional LiftMaster Exit Loop detector add-on board.
(J14)
OBSTRUCTION
Connector for factory-installed alarm.
ALARM