Baby Trend E30FL0211U 用户手册

proper angle of recline, place a rolled 

towel, or car seat noodle, under the 

base at the foot end to achieve the 

correct position.  (Fig. 48-1)

2. 

Safety Seat without Base:  Check 

that the Safety Seat is level side to side 

on the vehicle seat.  Check the level 

indicator as shown in Fig. 46-2.  

• If the Seat Angle Indicator shows NO 

red, the seat is installed at the proper 

level of recline.

• If the Seat Angle Indicator shows 

ANY 

red

, the Safety Seat is either 

too upright 

or too reclined

.  If the Safety Seat is 

too reclined adjust the Safety Seat as 

shown in Fig. 48-2 until the level indicator 

shows 

NO red

.  If the Safety Seat is too 

upright, place a tightly rolled towel, or 

car seat noodle, under the foot end of 

the Safety Seat until the level indicator 

shows 

NO red

. (Fig. 48-3)  Re-tighten the 

vehicle seat belt as instructed in section 

the Vehicle.

Fig. 48-1

Fig. 48-2

Fig. 48-3

1. If your child is already in the Safety Seat, check that the 

harness is properly fitted and tight as instructed in the section 

6.1, 

Securing your Child in the Safety Seat / Carrier.

2. Make sure that the Safety Seat is tightly installed and secure 

in the vehicle by performing the following test every time you 

use the Safety Seat.  Firmly push down and side to side on 

the head end of the Safety Seat to make sure that the vehicle 

seat belt does not loosen at all and that the vehicle seat belt is 

fastened very tightly around the Safety Seat / Base.  If you find 

that the vehicle seat belt loosens or that the seat easily moves 

or rotates downward, please see section entitled Selecting the 

Best Location for the Safety Seat to determine if the position 

you have selected is adequate and check that you have 

completed all of the steps in the section entitled Securing the 

Safety Seat or Base in the Vehicle. 

DO NOT use this seating location if the Safety Seat does not 

remain tightly installed in the vehicle seat!

3. Place handle in mid storage or non-rocking position after 

installing in the vehicle.