Baby Trend E30FL0211U 用户手册

1. Locate a 

LATCH seating position as identified in your vehicle 

owner’s manual.  Some 

LATCH seating positions may require 

deploying of anchors, or installation of guides.

2. Remove the Safety Seat from the base by squeezing the base 

release handle located under the center of the foot end of the 

Safety Seat and lifting upward on the Safety Seat.  (Fig. 25-1)

3. Remove the 

LATCH connectors from  

their storage position inside the base  

(Fig. 44-1).  Place the Base in the rear-

facing position in a forward facing vehicle 

seat as shown in Fig. 45-1.  

The Child 

must face the rear of the vehicle and 

Safety Seat must be placed in a vehicle 

seat that faces forward.

4. Locate the 

LATCH anchors in the vehicle 

seat. (Fig. 44-2)  Once located, snap the 

Safety Seat 

LATCH connectors onto the 

steel rod.  Listen for the click and check 

that both connectors are firmly attached to 

the anchor rods by pulling outward on the 

connectors.  (Fig. 45-2)

5. Proper installation of the Base requires 

that the 

LATCH webbing be very tight.  

To tighten the webbing, push down hard 

with your knee or hand on the Base while 

pulling upward on each webbing end.  

The webbing will automatically lock in 

Fig. 44-1

Fig. 44-2

Latch Anchor

place.  

Check that there is no slack in the 

webbing on both sides of the base and 

that the base is tightly installed.

  Fig. 45-2 

and 45-3.

6. Check that nothing is on top of the base or 

anything that will interfere with the proper 

latching of the Safety Seat to the Base.  Place 

the Safety Seat onto the Base and push down 

until the Safety Seat latches securely to the 

Base and you hear a click.  Pull upward on 

the Safety Seat to check that the Safety Seat 

is securely latched onto the base.  (Fig. 25-1) 

If the Safety Seat does not securely latch 

onto the Base, the Safety Seat will provide 

No Protection for your child.  

DO NOT use 

 the Safety Seat with the Base if it does not 

securely latch onto the Base.  Please call 

Baby Trend at 1-800-328-7363 for assistance.

 

7. To remove the base from the vehicle, 

squeeze the webbing release button 

on the 

LATCH connector to loosen the 

webbing.  (Fig. 46-1a)  Please note 

that the 

LATCH connector can not be 

released from the 

LATCH anchor if the 

webbing is tight.  Press the 

LATCH  

hook release button on each  

connector to release the connector  

from the anchor. (Fig. 46-1b) 

Fig. 45-1

Fig. 45-2

Fig. 45-3

Snap onto anchors