Dacor EF36BNFSS 用户手册

Page 2

STEP 2 (Model EF36BNFSS only):  
 

Using the T20 Torx driver and the screws removed in step 1, install the six (6) short 

mounting studs from the kit in the locations shown. 

New mounting 

stud from kit

Existing handle 

mounting screw

Handle Mounting 

Studs 

Set Screw Holes

Bottom (Freezer) Handle Installation
STEP 3:   Find the smallest of the three handles in the 

kit box.

STEP 4:   Mount the handle to the bottom drawer by 

sliding the holes on the back over the handle 

mounting studs on the refrigerator. Make sure 

the set screw holes on the handle are facing 

toward the bottom. You may need to loosen 

the set screws using a 3/32” Allen wrench to 

allow the handle to slide into place.

STEP 5:   Carefully tighten the set screws into place us-

ing the 3/32” Allen wrench. Be careful not to 

scratch the finish.

STEP 6:   Check to make sure the handle is firmly  

attached.