Omega VRT400 用户手册

18

19

Spinning brush

Silicone brush

Cleaning brush

Remove the spinning brush 

from strainer.

Detach the silicone brush from 

spinning brush.

  

As shown to the left, hold the outer part of 

silicone brush with your fingers an pull it out 

to the arrow direction. It is recommended 

to remove it according to the above method. 

If pulling it by force, silicone brush may be 

torn or spinning brush may be damaged.

With cleaning brush, wash inside and 

outside of spinning brush like brushing 

under the running water.

  

Wash silicone brush in the same way under 

the running water.

Brush 

groove

Outer wing

Down

(shorter part)

UP

(longer part)

Inner 

wing

Check the groove of the spinning brush 

and the direction of silicone brush.

  

There are grooves to insert silicone brush in 

the spinning brush. 

Silicone brush has inner wing   

and outer wing. 

  

As shown to the left, let ‘inner wing’ face 

the spinning brush.

Insert the silicone brush into 

the spinning brush.

  

According to the N o.1 above, let the longer 
part of inner wing   face upward.

  

Hold the outer wing   of silicone brush 

with your thumb and index finger and 

insert the inner wing into the groove 

of spinning brush.

Pull the inner wing tight enough.

  

Push silicone brush from the outer side 

of spinning brush and pull ‘inner wing’ in 

the direction of inside of the spinning brush 

with the other hand as shown to the left.

  

Hold the outer wing of silicone brush 

Pull it until you cannot pull it any longer. 

If units are operating without fully assembled, 

there is a risk of breakage.

  

Hold up and down of ‘outer wing’ and pull 

it tight enough.