Grizzly H8172 用户手册
H8172 Cement Mixer
-11-
Test Run
Once the assembly is complete and you have
read and understand this entire owner's manual,
connect the machine to the power source, then
test run the machine to make sure it runs prop-
erly.
read and understand this entire owner's manual,
connect the machine to the power source, then
test run the machine to make sure it runs prop-
erly.
If there is an unusual noise or vibration, stop
using the machine immediately and inspect the
machine for loose fasteners or improperly assem-
bled pieces. If you still cannot remedy a problem,
contact our Tech Support at (570) 546-9663 for
assistance.
using the machine immediately and inspect the
machine for loose fasteners or improperly assem-
bled pieces. If you still cannot remedy a problem,
contact our Tech Support at (570) 546-9663 for
assistance.
9. Place the upper drum on the lower drum with
the gasket between them. Align the arrows
shown in
shown in
Figure 11, and secure the upper
and lower drum pieces together with ten M8-
1.25 x 20 hex bolts, 8mm lock washers, and
8mm flat washers.
1.25 x 20 hex bolts, 8mm lock washers, and
8mm flat washers.
Note: Tighten these hex bolts progressively
in a criss-cross pattern for even tension all
the way around the drum.
in a criss-cross pattern for even tension all
the way around the drum.
11. Slide the motor assembly onto the bearing
block shaft, then secure the motor assembly
to the frame (
to the frame (
Figure 13). Use two 8mm flat
washers, lock washers, and hex nuts on the
motor assembly studs. Slide the remaining
M8-1.25 x 65 hex bolt through the motor
assembly and frame, then secure on the
other side with an 8mm flat washer, lock
washer, and hex nut.
motor assembly studs. Slide the remaining
M8-1.25 x 65 hex bolt through the motor
assembly and frame, then secure on the
other side with an 8mm flat washer, lock
washer, and hex nut.
Figure 13. Motor assembly attached to frame.
10. Place a plastic washer between the mounting
holes on the upper end of the mixing blades
and the upper drum. Insert an M10-1.5 x 20
Phillips screw from the outside of the drum
through each mixing blade. Secure each
screw with a 10mm flat washer, lock washer,
and hex nut from the inside (
and the upper drum. Insert an M10-1.5 x 20
Phillips screw from the outside of the drum
through each mixing blade. Secure each
screw with a 10mm flat washer, lock washer,
and hex nut from the inside (
Figure 12).
Completely tighten all the mixing blade fas-
teners now.
teners now.
Figure 12. Upper part of mixing blades attached
to upper drum.
Figure 11. Upper drum attached to lower drum.
Arrows
12. Attach the tipping wheel to the lower drum
pivot bar (
Figure 14). Use two M8-1.25 x
20 hex bolts on one side and two 8mm flat
washers, 8mm lock washers, and M8-1.25
hex nuts on the other side.
washers, 8mm lock washers, and M8-1.25
hex nuts on the other side.
Figure 14. Tipping wheel attached.
Tipping
Wheel