Grizzly G0495X 用户手册
g0495X 8" Jointer w/digital readout
-15-
figure 11. dust hose attached to dust port.
Dust collection
To connect the machine to a dust collector:
1. Fit a 4" dust hose that is connected to a dust
collector over the dust port, as shown in
figure 11, and secure in place with a hose
clamp.
clamp.
DO NOT operate the Model G0495X without
an adequate dust collection system. This
jointer creates substantial amounts of wood
dust while operating. failure to use a dust
collection system can result in short and
long-term respiratory illness.
Recommended cfM at Dust port: 400 cfM
Do not confuse this CFM recommendation with
the rating of the dust collector. To determine
the CFM at the dust port, you must consider
these variables: (1) CFM rating of the dust col-
lector, (2) hose type and length between the
dust collector and the machine, (3) number
of branches or wyes, and (4) amount of other
open lines throughout the system. Explaining
how to calculate these variables is beyond the
scope of this manual. Consult an expert or pur-
chase a good dust collection "how-to" book.
Do not confuse this CFM recommendation with
the rating of the dust collector. To determine
the CFM at the dust port, you must consider
these variables: (1) CFM rating of the dust col-
lector, (2) hose type and length between the
dust collector and the machine, (3) number
of branches or wyes, and (4) amount of other
open lines throughout the system. Explaining
how to calculate these variables is beyond the
scope of this manual. Consult an expert or pur-
chase a good dust collection "how-to" book.
2. tug the hose to make sure it does not come
off.
Note: A tight fit is necessary for proper per-
formance.
formance.
figure 12. Cutterhead insert at top-dead-center.
Ide9ZVY
8ZciZg
7diidb9ZVY
8ZciZg
Setting Outfeed
Table height
the outfeed table height must be level with the
carbide inserts when they are at top-dead-center.
if the outfeed table is set too low, the workpiece
will be tapered from front to back. if the outfeed
table is set too high, the workpiece will hit the edge
of the outfeed table during operation, increasing
the chance of kickback.
carbide inserts when they are at top-dead-center.
if the outfeed table is set too low, the workpiece
will be tapered from front to back. if the outfeed
table is set too high, the workpiece will hit the edge
of the outfeed table during operation, increasing
the chance of kickback.
To set the outfeed table height:
1. disConneCt Jointer From poWer!
2. move the cutterhead guard out of the way or
remove it, and remove the V-belt guard.
3. place a straightedge on the outfeed table
so it extends over the cutterhead and rotate
the cutterhead pulley until one of the carbide
inserts is at top-dead-center (tdC), as shown
in
the cutterhead pulley until one of the carbide
inserts is at top-dead-center (tdC), as shown
in
figure 12.
4. When correctly set, the carbide insert will just
touch the straightedge when the insert is at
its highest point of rotation (
its highest point of rotation (
figure 13).
figure 13. using a straightedge to align outfeed
table height with insert at tdC.
HigV^\]iZY\Z
Dji[ZZY
>c[ZZY