Wasp Bar Code WLS 8400 FZ 用户手册

1-6

4. Close the clamp, push it back into place and tighten the screws on the clamp to 

secure the cable into the bottom of the scanner. 

5. Connect the other end of the interface cable to the host (see the specific host chapter 

for information on host connections).

Different cables are required for different hosts. The connectors 
illustrated in each host chapter are examples only. The connectors 
may be different than those illustrated, but the steps to connect the 
scanner remain the same.

If the host does not provide power to the scanner, an external power connection is required 
to power the scanner. To connect power:

1. Connect the interface cable to the bottom of the scanner, as described in 

2. Connect the other end of the interface cable to the host (refer to the host manual to 

locate the correct port).

3. Plug the power supply into the power jack on the interface cable. Plug the other end 

of the power supply into an AC outlet.