Wasp Bar Code WLS 8400 FZ 用户手册

1-7

1. Loosen the two screws on the cable clamp at the bottom of the scanner and gently 

pull the clamp away from the bottom of the scanner.

2. Open the clamp and unplug the interface cable modular connector from the cable 

interface port on the bottom of the scanner handle. Carefully slide out the cable.

3. Follow the steps for 

 to connect a new 

cable.

Use the bar codes included in this manual to configure the scanner. See 

 and each host chapter for information about programming the scanner using 

bar code menus.