Wasp Bar Code WLS 8400 FZ 用户手册
Getting Started
1-7
Removing the Interface Cable
1. Loosen the two screws on the cable clamp at the bottom of the scanner and gently
pull the clamp away from the bottom of the scanner.
2. Open the clamp and unplug the interface cable modular connector from the cable
interface port on the bottom of the scanner handle. Carefully slide out the cable.
3. Follow the steps for
to connect a new
cable.
Configuring the Scanner
Use the bar codes included in this manual to configure the scanner. See
and each host chapter for information about programming the scanner using
bar code menus.