DELL 3424P 用户手册
84
Using Dell OpenManage Switch Administrator
www
.dell.com | support.dell.com
Telnet Connection
Telnet is a terminal emulation TCP/IP protocol. RS-232 terminals can be virtually connected to the
local device through a TCP/IP protocol network. Telnet is an alternative to a local login terminal
where a remote login is required.
local device through a TCP/IP protocol network. Telnet is an alternative to a local login terminal
where a remote login is required.
The device supports up to four simultaneous Telnet sessions to manage the device. All CLI
commands can be used over a telnet session.
commands can be used over a telnet session.
To start a Telnet session:
1
Select Start > Run.
The Run window opens.
2
In the Run window, type Telnet <IP address> in the Open field.
3
Click OK.
The Telnet session begins.
Using the CLI
This section provides information for using the CLI.
Command Mode Overview
The CLI is divided into command modes. Each command mode has a specific command set.
Entering a question mark at the terminal prompt displays a list of commands available for that
particular command mode.
Entering a question mark at the terminal prompt displays a list of commands available for that
particular command mode.
In each mode, a specific command is used to navigate from one command mode to another.
During the CLI session initialization, the CLI mode is the User EXEC mode. Only a limited subset
of commands are available in the
of commands are available in the
User EXEC mode. This level is reserved for tasks that do not
change the terminal configuration and is used to access configuration sub-systems such as the CLI.
To enter the next level, the Privileged EXEC mode, a password is required (if configured).
To enter the next level, the Privileged EXEC mode, a password is required (if configured).
The
Privileged EXEC mode provides access to the device global configuration. For specific global
configurations within the device, enter the next level, Global Configuration mode. A password is
not required.
not required.
The
Global Configuration mode manages the device configuration on a global level.
The Interface Configuration mode configures the device at the physical interface level. Interface
commands which require subcommands have another level called the Subinterface Configuration
mode. A password is not required.
commands which require subcommands have another level called the Subinterface Configuration
mode. A password is not required.