Renesas M16C PC4701 用户手册

3.2 Download of Firmware

It is necessary to down-load the firmware which corresponds to connected Emulation Pod when the
debugger is started to the emulator.
•

You have changed your emulation pod.

•

The firmware downloaded to the emulator is unknown one.

•

You have setup the debugger for the first time.

•

You have upgraded emulator debugger.

Press the system reset switch within two seconds after powering up the PC4701 to establish the
maintenance mode.
This debugger searches the version of the firmware downloaded to the emulator at start. Also when
the firmware downloaded to the emulator is of old version, a mode which drives this debugger to
download firmware is set.
When this debugger gets started while the emulator is set in the mode which drives the debugger to
download firmware forcedly, the following dialog is opened at start.
Click the OK button to download the firmware.

ATTENTION

•

If the emulator being used is the PC4701HS, use other communication methods (dedicated
parallel or serial) to download the firmware.

•

Before the firmware can be downloaded by the emulator in a LAN connection, the IP address, etc.
must first be registered in the emulator.