Renesas M16C PC4701 用户手册

3.3.2 LAN communication 1

Before the emulator can be connected in a LAN, the IP address, etc. must first be registered in the
emulator. For the emulator in default settings, the utility "setip.exe" included with the debugger may
be used to set the IP address, etc. in the emulator.

3.3.2.1 Setting of the LAN Interface using the SETIP.EXE

The utility "SETIP" included with this debugger may be used to set the IP address, etc. in the
emulator while in default settings. SETIP detects the Emulator's in default settings that are
connected to the same network. SETIP is stored in a location below the directory where this debugger
is installed . The file name is "setip.exe".

To register the IP address in the emulator, follow the procedure described below.
1. Connect the emulator with LAN cable to the same network (same subnet) as the host computer

is connected.

2. Set the emulator's communication interface switch to the "LAN" position. Then turn on the

power to the emulator.

3. Start SETIP. When SETIP has started up, the dialog box shown below appears, choose the

emulator of use, click the OK button.

4. Click the OK button, and showing information on the emulator connected to the network. (This

information consists of the MAC address followed by the serial number of the emulator.)

To register the IP address, click the Next button. To cancel registration, click the Close button. If not
displayed, check whether the communication interface switch is set correctly and after temporarily
turning off the power, turn it back on again. Then click the Search button.