Denon AVR-2312CI 用户手册

103

Speaker Config.
(Continued)

Surr.Back : Set the presence, size and number of surround back speakers.
• Large : Use a large speaker that can adequately play back low 

frequencies.

• Small : Use a small speaker that has inadequate playback capacity for 

low frequencies.

• None : Select when the surround back speakers are not connected.

• 2spkrs : Use two surround back speakers.
• 1spkr : Use only one surround back speaker. When you select this 

setting, connect the surround back speaker to the left (L) channel.

 Even when the “Surr.Back“ setting is other than “None”, sound 

may not be emitted from the surround back speaker, depending on 
the playback source. In this case, make “Surround Parameters” – 
“Surround Back” setting other than “OFF” (

When “Amp Assign” setting (

make the “Surr.Back” setting.
Front Height : Set the presence and size of the front height speakers.
• Large : Use a large speaker that can adequately play back low 

frequencies.

• Small : Use a small speaker that has inadequate playback capacity for 

low frequencies.

• None : Select when the front height speakers are not connected.

When “Amp Assign” setting (

) is “F.Height”, you can make 

the “Front Height” setting.

Bass Setting
Set subwoofer and LFE 
signal range playback.

Subwoofer Mode : Select low range signals to be reproduced by 
subwoofer.
• LFE : The low range signal of the channel set to “Small” speaker size is 

added to the LFE signal output from the subwoofer. 

• LFE+Main : The low range signal of all channels is added to the LFE 

signal output from the subwoofer.

• “Subwoofer Mode” can be set when “Speaker Config.” – “Subwoofer” 

) is set to “Yes”.

• Play music or a movie source and select the mode offering the strongest 

bass.

• Select “LFE+Main” if you want the bass signals to always be produced 

from the subwoofer.

If “Front” and “Center” for “Speaker Config.” are set to “Large”, and 
“Subwoofer Mode” is set to “LFE”, no sound may be output from the 
subwoofers, depending on the input signal or selected surround mode.
LPF for LFE : Set LFE signal playback range. Set this when you want to 
change the playback frequency of the subwoofer.
• 80Hz / 90Hz / 100Hz / 110Hz / 120Hz / 150Hz / 200Hz / 250Hz

vSee overleaf

BD