Motorola SBV6120E 用户手册

B 

3 Installing the Digital Voice Modem 

21

 

  

You can mount the SBV6120 horizontally or vertically. Do the following to mount your SBV6120 
on the wall: 

1.  Remove the four rubber chassis feet from the bottom of the SBV6120. 

2.  Print a copy of the 

.  

Make sure to print the template at 100% scale and that 

No Scaling is selected for Scale to 

paper size 

3.  Measure the printed template with a ruler to ensure that it is the correct size. 

4.  Use a center punch to mark the center of the holes. 

5.  On the wall, locate the marks for the mounting holes. 

6.  Drill the holes to a depth of at least 1 1/2 inches (3.8 cm). 

Use M3.5 x 38 mm (#6 x 11/2 inch) screws with a flat underside and maximum screw head 
diameter of 9.0 mm (.35 inches) to mount the SBV6120. 

7.  If necessary, install an anchor in each hole.  

8.  Using a screwdriver, turn each screw until the head protrudes from the wall, as shown in the 

following wall mounting screw dimensions illustration. 

6.0 mm (.24 inches) maximum

9.0 mm (.35 inches) maximum

2.5 mm (.10 inches).

 

There must be .10 inches (2.5 mm) between the wall and the underside of the screw head. 

The maximum distance from the wall to the top of the screw head is 6.0 mm (.24 in) 

9.  Place the SBV6120 so the keyholes on the back of the unit are aligned above the mounting 

screws. 

10.  Slide the SBV6120 down until it stops against the top of the keyhole opening. 

11.  After mounting, reconnect the coaxial cable input and Ethernet connection. 

12.  Plug the power cord into the power connector on the SBV6120 and the electrical outlet.  

13.  Route the cables so that they will not be a safety problem. 

You can print the following page to use it as the wall mounting template. Measure the printed 
template to verify the dimensions.