NEC LCD1510V 用户手册

The MultiSync LCD

1510

 / LCD

1510V

 / LCD

2010

 true colour monitor

complements PC compatible computers. Your system has one of two
configurations:

–

the video controller is built into the computer.

–

the video controller is in the form of a display card (sometimes
referred to as graphics card, video adapter or graphics board).

Both configurations have a video connector (or a CRT PORT on laptop
computers). If you are not sure which connector is the video connector,
refer to your computer or display card manual.

To attach the monitor to your system, follow these instructions:

1. Turn off the power to the monitor and computer.

2. If necessary, install the display card. For more information about

installing your card, refer to the display card manual.

3. Connect   the  15-pin  mini  D-SUB  of  the  appropriate  signal

cable to the connector of the display card in your computer.
Tighten all screws (Figure A.1).

4. For the MultiSync LCD

: Connect

the 15-pin mini D-SUB of the video signal cable and the AC
Adapter cable to the appropriate connectors on the back of the
monitor (Figure C.1).

: Remove connector cover on back

of monitor. Connect the BNC cables and AC adapter cable to
the appropriate connectors on the back of the monitor. Connect
the red BNC cable to the BNC connector on the monitor labeled
R, the green BNC cable to the BNC connector labeled G/Sync,
the blue BNC cable to the BNC connector labeled B. If you
have a fourth BNC connector (Composite Sync), connect it to
the BNC connector on the monitor labeled H/CS. If you have a
fifth BNC connector (Vertical Sync), connect it to the BNC

E - 8

Installation

78133551/Fix.PM5

98.3.17, 8:20 AM

22