NEC LCD1510V 用户手册

With the Macintosh cable adapter, the MultiSync LCD

1510

 /  LCD

1510V

/ LCD

2010

 colour monitor is compatible with the Macintosh family of

computers. You will connect your MultiSync colour monitor one of
two ways to your Macintosh computer:

–

On-board video port1

–

NuBus/PCI/PDS display card

Both configurations should have the same style video connector. If you
are not sure which port is the monitor connector, please reference your
computer or display card manual.

To attach your MultiSync LCD monitor to your system, follow these
instructions:

1. Turn off the power to your MultiSync LCD monitor and

Macintosh.

2. If neccssary, install the display card. For more information on

this installation, reference the display card manual.

3. Connect the MultiSync LCD

1510

, MultiSync LCD

1510V

 or

MultiSync LCD

2010

 Macintosh cable adapter to the computer

(Figure B.1). Attach the 15-pin mini D-SUB end of the
appropriate signal cable to the MultiSync LCD

1510

, MultiSync

LCD

1510V

 or MultiSync LCD

2010

 Macintosh cable adapter

(Figure B.1). Tighten all screws.

4. For the MultiSync LCD

: Connect

the 15-pin mini D-SUB of the video signal cable and the AC
Adapter cable to the appropriate connectors on the back of the
monitor (Figure C.1).

For the MultiSync LCD

2010

: Remove connector cover on back

of monitor. Connect the BNC cables and AC adapter cable to
the appropriate connectors on the back of the monitor. Connect
the red BNC cable to the BNC connector on the monitor labeled
R, the green BNC cable to the BNC connector labeled G/Sync,
the blue BNC cable to the BNC connector labeled B. If you
have a fourth BNC connector (Composite Sync), connect it to

Installation

E - 11

78133551/Fix.PM5

98.3.17, 8:20 AM

25