Tascam CC-222MKIV 用户手册
1 – Introduction
26
TASCAM CC-222
MK
IV
5 – Recording CDs
The trigger level can also be used to divide tracks if the
auto track function is enabled.
NOTE
When recording Vinyl to CD, since the track divisions
are determined by relative silence, it is possible that
spurious track divisions will be inserted. Under these
conditions, it may be better to set this function off, and
use manual track division explained below.
are determined by relative silence, it is possible that
spurious track divisions will be inserted. Under these
conditions, it may be better to set this function off, and
use manual track division explained below.
When this function is enabled, the unit automati-
cally inserts a track division in the recorded material.
Following modes are available for this function, and
are displayed as described.
cally inserts a track division in the recorded material.
Following modes are available for this function, and
are displayed as described.
•
LEVEL
When the sound level has dropped below the threshold
for more than two seconds, and sound has re-started, the
track will be divided.
A_LVL
At least
2 seconds
level
Track increment
time
•
DD
(digital direct)
When recording digitally from MD, CD or DAT, this
mode detects a track boundary and divides the track.
However, when the DD mode is on, and if the analog
source or non-DAT/CD/MD digital connections are
detected, the track number will be incremented using
level detection.
•
TIME
The track will be incremented as passing the time set
before recording using “A_TIME” in the menu items
(see “Menu operation” on page 15). The time can be set
1 minute to 10 minute increased by a minute.
•
OFF
This sets the function disabled (no indicator lit).
ª
To enable or disable automatic track division:
1 While record standby mode, press the
MENU
key
repeatedly until the display shows
A_TRK>XXX
where
XXX
is the current setting.
2 Use the
MULTI DIAL
or
SKIP
keys to select the de-
sired auto track setting.
The
A_TRACK
indicator lights at the right of the display.
When the
TIME
mode is selected, the indicator
will blink.
Automatic track division
Synchronized recording basically means that recording
will begin automatically when a signal is received, and will
stop when the signal ends.
To enable or disable synchronized recording:
1 A recordable disc must be loaded.
2 With the unit in record standby mode or record
To enable or disable synchronized recording:
1 A recordable disc must be loaded.
2 With the unit in record standby mode or record
mode, press the
SYNC REC
key.
The display shows
SYNC ON
briefly, and then
changes to the track and time display. When syn-
chronized recording is enabled, the
SYNC
indicator
lights in the display.
The
SYNC REC
key is also used to turn off synchro-
nized recording.
Synchronized recording
While recording is taking place, press the
RECORD
key.
The current track number is incremented by one.
NOTE
This operation cannot be applied while recording
track 99.
track 99.
Manually divide track