Konica Minolta VIVID 700 用户手册
188
Chapter
2
Build
Menu
Menu
9i
910
900
700
300
300
n
Moving the Point(s) by Entering Values
To move the point(s) by specifying how much they must be moved, follow the procedure given below.
Note
If
Build – Move – Points mode was activated using the shortcut key, the point(s) cannot be moved by this method.
Operating Procedure
The following steps must be carried out in
Build – Move – Points mode.
1
Click the right mouse button.
The [Build-Move-Points] dialog box will ap-
pear.
pear.
2
Enter the desired amount of movement
for X, Y and Z.
The amount can be entered for all the axes at
the same time.
the same time.
3
Click the [Apply] button.
The selected point(s) will move according to
the values entered.
the values entered.
• If you change a value(s) and click the [Apply]
button, the point(s) will move again according to
the new value(s).
the new value(s).
New values will not be added to the previous
values. They are absolute values from the original
position.
position.
4
Click the [OK] button.
The [Build-Move-Points] dialog box will close,
movement of the point(s) will be confirmed,
and the
movement of the point(s) will be confirmed,
and the
Build-Move-Points mode will be
canceled.
• Clicking the [Cancel] button will cancel all the
operations that have been performed since the
dialog box was opened.
dialog box was opened.
Build – Move – Points