National Instruments 370578B-01 用户手册
© National Instruments Corporation
2-1
2
Installation and Configuration
Installing the Software
(Windows 2000/NT/XP)
Complete the following steps to install your
NI-FBUS software.
Caution
If you are reinstalling the NI-FBUS software over an existing version, write down
your board configuration and any port configuration parameters you changed from the
default settings. Reinstalling may cause you to lose any existing board and port
configuration information.
default settings. Reinstalling may cause you to lose any existing board and port
configuration information.
1.
Log in as
Administrator
or as a user that has Administrator
privileges.
2.
Insert installation disk 1 or your NI-FBUS program CD.
3.
Select Start»Run.
4.
In the Run dialog box, enter
x
:\
setup
, where
x
is the letter of the drive
containing the disk (usually
a
or
b
).
The interactive setup program takes you through the necessary steps to
install the software.
install the software.
5.
At the end of the setup, the installer starts the NI-FBUS Interface
Configuration Utility as shown in Figure 2-1. If you have not yet
installed your HSE linking device, click OK to return. You will
install your HSE linking device in a later step.
Configuration Utility as shown in Figure 2-1. If you have not yet
installed your HSE linking device, click OK to return. You will
install your HSE linking device in a later step.
The installation program copies
nifb.dll
into the
\System32
directory.
The installation program also adds information to the Windows Registry.