National Instruments 370578B-01 用户手册

Figure 2-1.  The NI-FBUS Interface Configuration Utility

Continue to the Installing the HSE Linking Device section to configure and 
install your HSE linking device.

If you are using a National Instruments FBUS-HSE/H1 Linking Device as 
your HSE linking device, refer to the Installation Guide: FBUS-HSE/H1 
LD Fieldbus Network Module Linking Device and the FBUS-HSE/H1 
Linking Device (LD) User Manual for installation instructions.

If you are using an HSE linking device from a third-party vendor, refer to 
the documentation provided by the vendor to install your HSE linking 
device.

After you have configured and installed your HSE linking device, you are 
ready to set the NI-FBUS software.

To do this, you first must set the Ethernet interface. The Ethernet interface 
is an HSE interface that accesses an HSE linking device or HSE field 
device.