National Instruments 370578B-01 用户手册

Only one Ethernet interface can be added in the NI-FBUS software. If one Ethernet 

interface already exists in the interface list, the interface type Ethernet will be prohibited, 
and you cannot add a new Ethernet interface.

4.

Click Edit to display the NI-FBUS Interface Configuration Utility 
network communication information for the Ethernet interface

5.

Change the network communication parameter settings to the settings 
you want.

Do not modify the network communication parameters without good reason. 

If settings are incorrectly modified, the NI-FBUS software might not work well.

6.

After verifying the information you just entered, click OK.

Use the NI-FBUS Interface Configuration Utility to set the Fieldbus 
communication parameters and interface name by completing the 
following steps:

1.

Start the NI-FBUS Interface Configuration Utility. Select Start» 
Programs»National Instruments»NI-FBUS»Interface 
Configuration Utility.

2.

In the Interface Config window, select the icon of the HSE Linking 
Device you want to change and click Edit. If you are adding the HSE 
linking device, click Add Interface.

3.

Choose HSE/H1 LD as the Interface Type. The NI-FBUS Interface 
Configuration Utility listens on the Ethernet network and lists the 
found HSE linking devices with their IP addresses and Device IDs.

4.

Select the HSE linking device you want to add, and click Add.

5.

The NI-FBUS Interface Configuration Utility displays the device ID, 
device tag, IP address, and port number of the linking device as shown 
in Figure 2-3.