Vidikron VP-5000a 用户指南

Front L.E.D.: Select Front L.E.D. from the Option menu to change the behavior of the 
front-panel STANDBY/ON indicator LED (Figure 2-1). When set to ON, the LED indicates 
operating status as follows:

• Lights green to indicate normal operation; 

• Flashes green (once per second) when the AUTO OFF feature is active; 

• Lights red to indicate that the PlasmaView is in standby mode; 

• Flashes green or red (twice per second) to indicate an error condition.

When set to OFF, the LED lights red when the PlasmaView is in standby mode; otherwise, it is 
off. 

ISF Settings: The PlasmaView provides two “color modes,” NORMAL and ISF CCC. This allows 
you to create two, independent sets of image quality settings and switch from one to the 
other by selecting a color mode. 

Select ISF Settings from the Option menu. Then, press SET to select either NORMAL or 
ISF CCC. Any subsequent changes to image quality settings are stored and can be recalled by 
selecting that color mode.

Vidikron Pro: Select Vidikron Pro from the Option menu to access these advanced image 
processing settings.

• Underscan: Underscan causes the outer edge of the display to appear beyond the normal 

effective data area for a video signal. 

To use Underscan, select it from the Vidikron Pro menu and set it to ON. Then, exit the 
menu system and use the ASPECT RATIO remote control button to select Underscan 
mode. 

• Display Profile: Select NORMAL or PURE to see the normal color gamut. Select 

MONOTONE to remove all color information from the image. Select HIGH CNT to increase 
the color temperature by approximately 2,000K. 

• Signal Type: For most source material types, the appropriate Signal Type setting is 

MOTION. However, with certain interlaced and/or composite video images with few or no 
moving objects, STILL or NON-STD may yield better results. 

Select Return to exit the Vidikron Pro menu. 

FRC: Select FRC from the Option menu to enable frame rate conversion. Set FRC to NORMAL 
if you notice and want to minimize motion blur when viewing source material that 
originated from film. If frame rate conversion is not needed, set FRC to SCALER. 

Power On Mode: Select Power On Mode from the Option menu to specify which input 
signal is displayed when you turn on the PlasmaView. You can also specify an initial audio 
volume level. 

You can select a specific input or volume level (0 to 42). Or, select LAST to have the 
PlasmaView set the input and volume to what they were the last time it was turned off.