Intel DX48BT2 用户手册

69 

1.  Assemble your system and attach two External SATA hard drives to the Desktop 

Board’s two back panel eSATA connectors. 

2.  Enter system BIOS Setup by pressing the <F2> key after the Power-On-Self-Test 

(POST) memory tests begin.  

3.  Go to Advanced   Peripheral Configuration   Secondary SATA Controller; 

ensure that RAID is selected.  

4.  Then save your settings by pressing <F10>. 

1.  Upon re-boot, you will see the following Marvell Storage Manager option ROM 

status message on the screen:  Press <Ctrl-M> to enter the RAID 
Configuration Utility

.  Press <Ctrl-M> and enter the RAID Configuration 

Utility. 

2.  In the Marvell Storage Manager option ROM Main Menu, select: Create RAID 

Volume

.  Enter a volume name (using English alphanumeric ASCII characters) and 

press <Enter>. 

3.  Use the arrow keys to select RAID 0 or RAID 1.  Press <Enter> once you have 

selected the RAID LEVEL.  

4.  Select the strip size, if necessary, and press <Enter>.   
5.  Enter the size of the volume (if you enter less than the maximum volume size, you 

can then create a second RAID array on the remaining portion of your volume) and 
press <Enter>.   

6.  Finally, press <Enter> to Create Volume.  
7.  Exit the Option ROM user interface by pressing <Esc> or going to the EXIT option 

in the MAIN MENU. 

1.  Begin Windows Setup by booting from the Windows installation CD. 
2.  At the beginning of Windows Setup, press <F6> to install a third-party SCSI or 

RAID driver.  When prompted, insert the diskette that contains the Marvell Storage 
Technology RAID Driver in a USB floppy disk drive.  Refer to 

 for information on supported USB 

floppy disk drives.  Install the Marvell 88SE61XX SATA RAID Controller driver. 

3.  Finish the Windows installation and install all necessary drivers.