TP-LINK TD-W8960N Benutzerhandbuch

30 

Type the new value for the WAN Interface who’s MAC Address you want to change. 

You can select corresponding WAN Interface from the drop-down list and click Clone button to 
clone your current PC MAC. 

Click Restore Default button to restore the WAN Interface’s default MAC Address. 

)

Only the WAN Ports can use MAC Address Clone function. All the clone MAC addresses must not 
be the same with each other. 

Choose “Advanced Setup”Æ“LAN”, and you will see the LAN screen (shown in Figure 4-21), the 
section allows you to configure the Router’s LAN ports settings. 

 

Figure 4-21 

¾

  IP Address: You can configure the Router’s IP Address and Subnet Mask for LAN Interface. 

•  IP Address: Enter the Router’s local IP Address, then you can access to the Web-based 

Utility via the IP Address, the default value is 192.168.1.1. 

•  Subnet Mask: Enter the Router’s Subnet Mask, the default value is 255.255.255.0. 

¾

  Enable IGMP Snooping: If you select the option, please choose the IGMP Mode: Standard 

Mode or Blocking Mode. 

¾

  DHCP Server: These settings allow you to configure the Router‘s Dynamic Host 

Configuration Protocol (DHCP) server function. The DHCP server is enabled by default for the 
Router’s Ethernet LAN interface. DHCP service will supply IP settings to computers which are 
configured to automatically obtain IP settings that are connected to the Router though the 
Ethernet port. When the Router is set for DHCP, it becomes the default gateway for DHCP