Epson 800N Benutzerhandbuch

If you receive 4 lines that say “Request Timed Out,” the 
card is not set up correctly. Check to make sure the card is 
on the same segment of the network as the workstation you 
are using to configure it and that you typed in the correct 
IP and hardware addresses.

Before you can print using TCP/IP, you still need to install the 
Status Monitor (see page 24) and add a printer port (see 
page 27).

Follow these steps if you need to set up Windows NT to print 
with TCP/IP:

1. Open the Control Panel.

2. Double-click the 

Network

 icon.

3. In Windows NT 4.x, click the

 Services

 tab. If 

Microsoft 

TCP/IP Printing

 is listed under Network Services, you can 

skip to “Configuring the Ethernet Card for TCP/IP” on 
page 18. If it is not, click 

Add

.

In Windows NT 3.5x, if 

Microsoft TCP/IP Printing

 is 

listed under Installed Network Software, you can skip to 
“Configuring the Ethernet Card for TCP/IP” on page 18. 
If it is not, click 

Add Software

.

4. In Windows NT 4.x, select 

Microsoft TCP/IP Printing

 

from the Network Service list and click 

OK

. Continue with 

step 6.

In Windows NT 3.5x, select 

TCP/IP Protocol and related 

component

s from the Network Software list and click 

Continue

.

5. In Windows NT 3.5x, select 

TCP/IP Network Printing 

Support

 in the Windows NT TCP/IP Installation Options 

dialog box and click 

Continue

. 

QuikSet2.fm  Page 17  Wednesday, October 15, 1997  3:49 PM