Epson 800N Benutzerhandbuch

3. Set the following options in the IP Config dialog box:

◗

IP address 

Determine and assign an IP address. Check with your 
network administrator or see the note below for 
information about assigning IP addresses.

◗

Subnet mask

Assign the subnet mask. Check with your network 
administrator or see the note below for information 
about assigning subnet masks.

◗

Auto IP address

Set to 

Off.

4. After making your settings, click 

Save

.

After you configure your printer, you need to install EPSON 
Status Monitor 2. See page 24 for instructions.

If you don’t have a network administrator, you can assign IP 
addresses in the range of 192.168.1.1 to 192.168.1.254. Each 
computer or other device connected directly to the network 
must have a unique IP number. The subnet mask should be 
255.255.255.0. However, you should not use these addresses if 
your network has a direct (rather than dial-up) connection to 
the Internet.

If you use Windows NT, the Ethernet card can work with the 
DLC (Data Link Control) support provided in your operating 
system. Follow the instructions below to install DLC support in 
Windows and configure the printer.

Caution:
Once you make changes 
to the Ethernet card, 
wait for at least five 
minutes before turning 
off or restarting your 
printer. 

QuikSet2.fm  Page 19  Wednesday, October 15, 1997  3:49 PM