Smeg AP64S3 Benutzerhandbuch

 

 

   
  Before performing any cleaning or maintenance work, disconnect the 

 

   

 

  The hob has been inspected for G20 (2H) natural gas at a pressure of 

20 mbar. For functioning with other types of gas the nozzles must be 
replaced and the primary air adjusted. 
To replace the nozzles and regulate the burners, you have to remove 
the top as described in the following paragraph. 

 

   

 

 

 

  

1.

  Remove the knobs and the knob guard 

tube “A” by pulling them up; 

2.

  Use a crosshead screwdriver to remove 

the screws and the two cylindrical 
supports “B”; 

3.

  Raise the left-hand side of the control 

panel slightly and shift it to the right to 
remove it completely; 

4.

  In models with electric hotplate, the body 

of the pilot light has to be removed to free 
the control panel; 

 

 

 

   

 

 

 

  1.  Remove the knobs, the 

griddles, the burner caps, the 
flame caps and the two rear 
plugs; 

2.

  Remove the screws “A” 

which fix the burner supports;

3.

  Raise the hob, sliding it off 

the ignition plugs and/or the 
thermocouples and the gas 
tap rods;