Honeywell HE360 Installationsanleitung
HE360 HUMIDIFIER INSTALLATION KIT
69-1572
4
d. Insert the tubing into the solenoid valve fitting
and support the valve while tightening the com-
pression nut.
pression nut.
NOTE:
Do not over-tighten the compression nut. Mod-
erate tightness prevents leaking.
erate tightness prevents leaking.
e. Repeat steps a. through d. for solenoid valve
fitting.
f.
Secure tubing with clamps provided.
Fig. 6. Installing feed tubing.
4.
Connect a 1/2 in. (13 mm) drain tube to the humid-
ifier drain fitting and run to the floor drain (see Fig.
7).
a. Slide the drain clamp over the tubing.
b. Push the tubing over the drain nipple on the
ifier drain fitting and run to the floor drain (see Fig.
7).
a. Slide the drain clamp over the tubing.
b. Push the tubing over the drain nipple on the
humidifier.
c. Hand-tighten the clamp around the tubing to
secure the humidifier drain.
d. Fasten the drain tubing (can use duct tape)
along the route to prevent movement and
ensure downward slope for correct drainage.
ensure downward slope for correct drainage.
NOTE:
Cut tubing to correct length so the tubing termi-
nates at the drain.
nates at the drain.
Fig. 7. Installing drain tubing.
Installing Sail Switch
Adapting Switch to Air Flow Direction
The S688A Sail Switch is provided with two
counterbalancing springs in place as shown in Fig 8.
These springs offset the effect of gravity for air flow
direction.
counterbalancing springs in place as shown in Fig 8.
These springs offset the effect of gravity for air flow
direction.
IMPORTANT:
Do not use the sail switch with both springs
attached. Be sure to select air flow direction and
remove spring(s) not required for installation.
attached. Be sure to select air flow direction and
remove spring(s) not required for installation.
Fig. 8. Adapting sail switch to air flow direction or
mounting position.
•
Vertical
downward
air flow: Leave the spring in
place that is attached to the bracket marked Down.
Remove the spring that is attached to the bracket
marked Up.
Remove the spring that is attached to the bracket
marked Up.
•
Vertical
upward
air flow: Leave the spring in place
that is attached to the bracket marked Up. Remove
the spring that is attached to the bracket marked
Down.
the spring that is attached to the bracket marked
Down.
•
Horizontal air flow: Remove both springs.
1.
Mount the template (provided with the sail switch)
at the desired location.
at the desired location.
NOTE:
Be sure the arrow (indicating air flow) points in
the correct direction.
the correct direction.
a. For horizontal mounting,
level
the long dimen-
sion shown on the template.
b. For vertical mounting,
plumb
the long dimen-
sion.
2.
Cut the hole (indicated on the template) in the duct-
work.
work.
3.
Center punch the screw holes indicated and drill
out with a 1/8 in. (13 mm) drill.
out with a 1/8 in. (13 mm) drill.
4.
Attach the sail to the switch as shown in Fig 9.
M20176
BRASS COMPRESSION NUT
PLASTIC
COMPRESSION RING
COMPRESSION RING
BRASS INSERT
M20177
UP
M3014