Benutzerhandbuch für Impex MD-377

Inhaltsverzeichnis

• BEFORE YOU BEGIN...................................................................................…. 1

  2
• IMPORTANT SAFETY NOTICES..................................................................…. 2

  2
• HARDWARE IDENTIFIER.....…....................................................................…. 4

  2
• ASSEMBLY INSTRUCTIONS........................................................................…. 5

  2
• EXPLODED DIAGRAM………………………………………………………………. 10

  2
• PARTS LIST...............................................................................................……. 11

  2
• WARRANTY.................................................................................................…. 12

  2
• ORDERING PARTS.......................................................................................… 12

  2
• HARDWARE PACK

  5
  • ASSEMBLY INSTRUCTION

    6
    • Attach the Leg Developer (#7) to the Front Leg (#5). Secure it with one M8 x 3 1/8” Allen Bolt (#31), two Ø 5/8” Washers (#35), and one M8 Aircraft Nut (#39).

      8
    • Insert two Foam Tubes (#11) halfway through the holes on the Leg Developer. Push four Foam Rolls (#22) onto the Tubes from both sides.

      8
    • Attach the Backrest Supports (#12) onto both ends of the pivot on the Main Seat Support (#3). Place the other end rest against the Backrest Adjustment Bar (#9).

      9
    • Place the Backrest Board (#26) onto the Backrest Supports. Secure it with four M6 x 1 ½” Hex Bolts (#32) and Ø ½” Washers (#36).

      9
    • Place the Seat Pad (#33) onto the Main Seat Support. Secure it with four M6 x 1 ¼” Hex Bolts (#33) and Ø ½” Washers (#36).

      9
      • DIAGRAM 4

        9
    • Attach the Arm Curl Pad (#24) to the Arm Curl Stand (#6). Secure it with two M8 x 5/8” Allen Bolts (#30) and two Ø 5/8” Washers (#35).

      10
    • Insert the Arm Curl Stand into the top opening on the Front Leg (#5). Use a Lock Knob (#14) to hold the Arm Curl Stand in position.

      10
      • DIAGRAM 5

        10
    • 1 Right Upright Beam 1

      12
    • 19 Front Leg End Cap 1

      12
    • 20 Ø 2 3/8” x Ø 2” Sleeve 1

      12
    • 21 Ø 2” End Cap 3

      12