Whirlpool W10392127B-SP User Manual

Using pliers, tighten the couplings with additional  

two-thirds turn.

NOTE: Do not overtighten. Damage to the coupling can result.

If space permits, attach the female end of the “Y” connector 

to the cold water faucet. See figure A.

If “Y” connector cannot be attached directly to the cold water 

faucet, the short hose must be used. See figure B. Attach 

short hose to cold water faucet. Screw on coupling by hand 

until it is seated on faucet. Then attach “Y” connector to the 

male end of the short hose. Screw on coupling by hand until 

it is seated on connector.

Fig. A

Fig. B

One end of the long hose has a wire mesh strainer inside the 

coupling. Attach this end to the “Y” connector. Attach washer 

cold inlet hose to other side of “Y” connector. Screw on 

coupling by hand until it is seated on connector. Using pliers, 

tighten the couplings an additional two-thirds turn.

NOTE: Do not overtighten. Damage to the coupling can result.

Attach other end of long hose  

to fill valve at bottom of dryer  

back panel. Screw on coupling  

by hand until it is seated on fill 

valve connector. Using pliers, 

tighten the couplings an additional 

two-thirds turn.

NOTE: Do not overtighten. Damage 

to the coupling can result.

Check that the water faucets are turned on.

Check for leaks around “Y” connector, faucets, and hoses.