Whirlpool W10392127B-SP User Manual

q

  Check that all parts are now installed. If there is an extra  

part, go back through steps to see what was skipped.

q

  Check that you have all of your tools.

q

  Dispose of/recycle all packaging materials.

q

  Be sure the water faucets are on.

q

  Check for leaks around “Y” connector, faucets, and hoses.

q

  Check dryer’s final location. Be sure vent is not crushed  

or kinked.

q

  Check that dryer is level. See “Level Dryer.”

q

  Remove film on console and any tape remaining on dryer.

q

  Wipe dryer drum interior thoroughly with a damp cloth to 

remove any dust.

q

  Read “Dryer Use” in your “Use and Care Guide.”

q

  If you live in a hard water area, use of a water softener is    

recommended to control the buildup of scale through the    

water system in the dryer. Over time, the buildup of lime  

scale may clog different parts of the water system, which will  

reduce product performance. Excessive scale buildup may  

lead to the need for certain part replacement or repair.

q

  Plug into a grounded outlet.

q

  Check that gas supply is on.

q

  Check for leaks.

q

  Select a Timed Dry heated cycle, and start dryer. Do not  

select Air Only Temperature setting.

 If dryer will not start, check the following:
 • Controls are set in a running or “On” position.
 • Start button has been pushed firmly.
 • Dryer is plugged into an outlet and/or electrical supply is

   connected.
 • Household fuse is intact and tight, or circuit breaker has  

    not  tripped.
 • Dryer door is closed.

This dryer automatically runs an installation diagnostic routine  

at the start of its first cycle.

You may notice an odor when dryer is first heated. This 

odor is common when heating element is first used. The odor will 

go away.

You can change your door swing from a right-side opening  

to a left-side opening, if desired.

1.  Place a towel or soft cloth on top of dryer or work space  

to avoid damaging the surface.

1. Open the dryer door.
2.  Remove the bottom screw (B) from each of the two hinges  

that attach dryer door to front panel of dryer.

3.  Loosen the top screw (A) from each of the two hinges  

in Step 2.

4.  Remove the dryer door and the hinges by lifting upward  

on the door. Lay the door on a flat, covered surface, with  

the inside of the door facing up. Remove remaining two  

loose screws from dryer front panel.

  

Remove the 4 plastic plugs (A) located outside the dryer  

door opening.

6.  Install 4 plastic plugs (A) into screw holes in the dryer left  

where the hinges were removed in Step 4.