Whirlpool W10150626A User Manual

Gather the required tools and parts before starting installation. 
Read and follow the instructions provided with any tools listed 
here. 

Remove parts package from dryer drum. Check that all parts 
were included.

Check local codes and consult gas supplier. Check existing gas 
supply, electrical supply and venting, and read “Electrical 
Requirements,” “Gas Supply Requirements” and “Venting 
Requirements” before purchasing parts.

Mobile home installations require special parts (listed following) 
that may be ordered by calling the dealer from whom you 
purchased your dryer. For information on ordering, please refer to 
the “Assistance or Service” section. You may also contact the 
dealer from whom you purchased your dryer.

■

Mobile home installation kit. Ask for Part Number 346764.

■

Metal exhaust system hardware.

■

A location that allows for proper exhaust installation. See 
“Venting Requirements.”

■

A separate 30-amp circuit.

■

A grounded electrical outlet located within 2 ft (61 cm) of 
either side of the dryer. See “Electrical Requirements.”

■

A sturdy floor to support the total weight (dryer and load) of 
200 lbs (90.7 kg). The combined weight of a companion 
appliance should also be considered.

■

A level floor with a maximum slope of 1" (2.5 cm) under entire 
dryer.

Do not operate your dryer at temperatures below 45ºF (7ºC). At 
lower temperatures, the dryer might not shut off at the end of an 
automatic cycle. Drying times can be extended.

The dryer must not be installed or stored in an area where it will 
be exposed to water and/or weather.

Check code requirements. Some codes limit, or do not permit, 
installation of the dryer in garages, closets, mobile homes or 
sleeping quarters. Contact your local building inspector.

NOTE: No other fuel-burning appliance can be installed in the 
same closet as a dryer.

The location must be large enough to allow the dryer door to 
open fully. 

■

8" or 10" pipe wrench

■

8" or 10" adjustable 
wrench (for gas 
connections)

■

Flat-blade screwdriver

■

Adjustable wrench that 
opens to 1" (2.5 cm) or 
hex-head socket wrench 
(for adjusting dryer feet)

■

Level

■

¼" nut driver or socket 
wrench

■

Knife

■

Vent clamps

■

Pipe-joint compound 
resistant to LP gas

■

Caulking gun and 
compound (for installing 
new exhaust vent)

■

Pliers