Whirlpool W10240585C-SP User Manual

To reduce the risk of fire, this dryer MUST BE 

EXHAUSTED OUTDOORS.

Observe all governing codes and ordinances.

Dryer exhaust must not be connected into any gas vent, 

chimney, wall, ceiling, attic, crawlspace, or a concealed space 

of a building. Only rigid or flexible metal vent shall be used for 

exhausting.

Only a 4" (102 mm) heavy metal exhaust vent and clamps  

 

■

may be used. 

Do not use plastic or metal foil vent.

 

■

Recommended for best drying performance and to avoid 

 

■

crushing and kinking.

(Acceptable only if accessible to clean)

Must be fully extended and supported in final dryer location.

 

■

Remove excess to avoid sagging and kinking that may  

 

■

result in reduced airflow and poor performance.

Do not install in enclosed walls, ceilings, or floors.

 

■

The total length should not exceed 7 

 

■

3

/

4

 ft. (2.4 m).

If using an existing vent system, clean lint from  

entire length of the system and make sure exhaust hood  

is not plugged with lint. Replace plastic or metal foil vents  

with rigid metal or flexible metal vents. Review Vent System  

Chart and if necessary, modify existing vent system to  

achieve best drying performance.

4" (102 mm) heavy metal exhaust vent

Louvered Hood

        Good

Angled Hood

Box Hood

      Better

45° elbows provide better airflow than 90° elbows.

 

■

Use clamps to seal all joints.

 

■

Exhaust vent must not be connected or secured with screws 

 

■

or other fastening devices that extend into interior of duct  

and catch lint. Do not use duct tape.

Must be at least 12" (305 mm) from ground or any object that 

 

■

may obstruct exhaust (such as flowers, rocks, bushes, or 

snow).

Vent products can be purchased from your dealer. For more 

information, see “Assistance or Service” section in your “Use and 

Care Guide”.