Hearth & Home Technologies 5100I-NL-B User Manual

5100-I ACT WOOD INSERT

Page 0

September 1, 2008

438-0380D

Figure 20.1

Figure 20.2

Figure 20.3

Two leveling bolts, 3/8” x 4” are shipped inside the com-

ponent pack found inside the firebox.
NOTE: Not all installations will require the use of the level-

ing bolts.
1. Remove the bolts from the component pack and insert

into weld nuts welded to each side of the insert bottom

Figure 20.1

. After securing the liner to the flue collar (or offset adapter)

and the insert is in its final position, extend bolts down-

ward to level insert.

B. Leveling Bolts

Appliance Set-up

Standard Size: 30-1/2” h x 47” w
Large Size: 34-1/4” h x 51-1/4” w

Do not tighten sides until

top is locked into place

Panel brackets

a. Loosely install the 2 side panels, do not tighten, using

the cage nuts already attached to the appliance.

(Note: The sides are not interchangeable).

Figure

20.3.

b. Put top panel in place pushing straight back and then

to the right to lock onto top of side panels. Attach

the top panel to the sides using the panel brackets

included in the fasteners package.

Figure 20.2

c. Tighten side panels to the appliance using a long-

handle screw driver.

Back view of top and

side panel assembled

Panel

bracket

Cage nut

1. Attaching Panels to the Insert

C. Panel & Trim Set Installation

Kit Includes:

() Side panels, left & right

(1) Panel top & fastener package

() Side trim, left & right

(1) Trim top & fastener package.

Tools Needed

Screwdrivers:

Powered Phillips head

Long-handled Phillips head

A. Installation Outline

1. Record serial number on back cover of manual.
. Remove the leveling bolts from the component pack and

start the bolts in the weld nuts.

Figure 20.1

. Position insert on hearth with rear of insert extending into

fireplace opening. Slide insert on its base into the open-

ing leaving approximately 4 inches (102mm) protruding

out the front.

4. Assemble the panels and temporarily attach to insert.

Push insert into opening leaving 1 inch (5mm) protrud-

ing out the front. Confirm the panel size is correct for the

opening and that the face can be sealed off from room

air when installation is complete.

Figure 20.2 & 20.3.

5. Remove the panels and secure liner to the chimney

ring.

6. Level the insert in its final position in the fireplace. If an

offset adapter is required for installation, install it first and

then secure liner to offset adapter.

. Install the Panel & Trim set and (if applicable) the Zero

Clearance Trim Support.

,EVELING