Hearth & Home Technologies 5100I-NL-B User Manual

Page 

September 1, 2008

R 

438-0380D

1.  The 10 screws on each set of scissors will already be

loose when shipped.

2.  Expand  scissors  to  desired  height.   Tighten  screws  to

hold  in  place  using  Phillips  Head  screwdriver. 

.  Measure front and side trims to required height to cover  

scissors and mark pieces for cutting.  Cut excess mate-

rial from

top of trim’s edge, not bottom. This edge will

be sharp; wear gloves to prevent injury to your hands.

.  Using  sheet  metal  shears,  cut  trim  along  the  marked 

edge.  The cut edge fits under lip of top trim, so it allows 

for some variance in your straight edge.

5.  The double-sided tape that holds front and side trims to

scissors  has  a  particularly  powerful  bonding  adhesive.

Adjustments are extremely difficult once trim has adhered 

to tape.  Do a dry run first without removing paper from 

tape.

6.  Place cut edge of trim under top lip and into position on 

scissors.  Place side pieces on first and then front piece.  

The front piece overlaps side pieces.

.  Once you are satisfied with the positioning, remove trim 

and set aside.

8.  Remove  the  paper  from  double-sided  tape  that  is  to

accept trim side. Align side and then press hard against

tape to secure side piece. Repeat for other side. Install

front trim piece last.

NOTE: /8 inch (9.5mm) thick tile or like material can be cut to 

size and fit under lip of  top trim edge for a decorative touch.  

(

1) Trim top

(1) Trim front

(2) Trim sides

Double-sided tape

(already installed)

Phillips head screwdriver

Sheet metal shears

Measuring tape

Gloves

Decorative tile may 

be installed

Sharp Edges
•  Wear protective gloves during installation.

DOUBLE-SIDED TAPE

DOUBLE-SIDED TAPE