Hearth & Home Technologies 5100I-NL-B User Manual

Page 1

R 

438-0380D

September 1, 2008

There  are  two  options  to  secure  the  liner  to  the  chimney

ring:

Option One: If there is enough room on the top of the insert

to work, hand bend the  tabs upward 90°.  Secure the liner 

with the supplied hex head bolts 1/4-20-3/4.
Option Two:  Remove the manifold tubes, fiberboard baffle 

and ceramic blanket.  From inside the firebox, pull liner down 

through the chimney ring below the outer skin.  There are  

pre-drilled holes in the chimney ring 180° apart.  Secure the 

liner with the supplied hex head bolts 1/4-20-3/4.

ures 32.3 and 32.4 on page 32 for details for removing the

manifold tubes, baffle and ceramic blanket.

NOTE:  Tabs are shipped from factory in a flat position. 

Bend upwards 90 degrees as show in

2 pre-drilled holes on flue 

collar under outer skin 

(access through firebox)

Attach liner with 2 tabs

a.  Place  protective  covering  on  surface  to  be  used  to 

assemble the trim pieces. Lay the trim face down.

b.  Attach the 2 side trim pieces to the top trim at each

corner  using  the  “L”  bracket  included  in  fasteners 

package.  Slide assembled trim over panel set.

 NOTE: If you have a mantel, you may need to install the

trim on your panels before you push the insert into the

fireplace opening.  If not, you can slide the trim over 

the panel set after the insert is in its final position.

View of “L” bracket installed