Mitsubishi Electronics 60/60S User Manual

4.  Parameters (User) 

4.2  Machining Parameters 

 

 

 

I-151 

8072 SCALING P 

(for M system only) 

Set the scale factor for reduction or magnification for 
the machining program for which the G50 or G51 
command is issued. 
This parameter is effective when the program 
specifies no scale factor. 

0 to 99.999999 

 
<Tool ID> 

8073 OfsetPosition 

(for M system only) 

Set the tool offset memory number position for 
writing the tool information data's tool length offset 
amount, tool radius compensation amount, tool 
length wear amount and tool radius wear amount 
into the tool offset data. 
Note:  If 0 or a value exceeding the number of tool 

compensation sets is set, the data will not be 
written into the tool offset data. 

0 to 999 

8074 IDMacroTop 

(for M system only) 

Set the head position when writing the tool 
information data's user areas 4 to 9 in the macro 
variables. 

0 to 999 

 
<Spiral interpolation> 

8075 SpiralEndErr 

(for M system only) 

Designate the tolerable error range (absolute value) 
when the end point position commanded with the 
command format type 2 spiral interpolation or conical 
interpolation command differs from the end point 
position obtained from the speed and increment/ 
decrement amount. 

0 to 99999.999 (mm)

8076 SpiralMinRad 

(for M system only) 

Not used. 

 

 
<Involute interpolation> 

8077 InvoluteErr 

(for M system only) 

Set the tolerable error value of the involute curve 
that passes through the start point and the involute 
curve that passes through the end point during 
involute interpolation. 

0 to 99999.999 (mm)

 
<Screen saver> 

8078 Screen Saver 

Set the time to turn the screen OFF. 
The screen saver will not turn ON if 0 is set. 
(Note) This parameter setting is valid only for the 

LCD display unit. 

0 to 60 (min) 

0: Do not turn screen 

OFF.