Mitsubishi Electronics 60/60S User Manual

4.  Parameters (User) 

4.2  Machining Parameters 

 

 

 

I-152 

8083 G83S modeM 

(for M system only) 

Set the M command code for changing to the small 
diameter deep hole drilling cycle mode. 

1 to 99999999 

8084 G83S Clearanse 

(for M system only) 

Set the clearance amount for the G83 small 
diameter deep hole drilling cycle. 

0 to 999.999 (mm) 

8085  G83S Forward F 

(for M system only) 

Set the feedrate from the R point to the cutting start 
position in the G83 small diameter deep hole drilling 
cycle. 

0 to 99999 (mm/min)

8086  G83S Back F 

(for M system only) 

Set the speed for returning from the hole base 
during the G83 small diameter deep hole drilling 
cycle. 

0 to 99999 (mm/min)

 
<SSS control> 

8090 SSS ON 

(for M system only) 

Set whether to validate SSS control with G05 
P10000. 

0: Invalid 
1: Valid 

0/1 

8091 StdLength 

(for M system only) 

Adjust the maximum value of the range for 
recognizing the shape. 
To eliminate the effect of steps or errors, etc., set a 
large value. To enable sufficient deceleration, set a 
small value. 
If "0.000" is set, the standard value (1.000mm) will 
be applied. 

0 to 100.000 (mm) 

8092 ClampCoeff 

(for M system only) 

Adjust the clamp speed at the curved section 
configured of fine segments. 

Coefficient =  

 setting value 

1 to 100 

8093 StepLeng 

(for M system only) 

Set the width of the step at which the speed is not to 
be decelerated. (Approximately the same as the 
CAM path difference [Tolerance].) 
If 0 is set, the standard value (5µm) will be applied.
If a minus value is set, the speed will decelerate at 
all minute steps. 

-0.001 to 0.100 (mm)

8094 DccWaitAdd 

(for M system only) 

Set the time to wait for deceleration when the speed 
FB does not drop to the clamp speed. 

0 to 100 (ms) 

8095 Tolerance 

(for M system only) 

Set the tolerable error when the error between the 
command path and tool path is large. 
The error will decrease when a small value is set, 
but the machining time will increase. 
If "0.000" is set, the error will not be adjusted. 

0 to 100.000 (mm)