Mitsubishi Electronics 60/60S User Manual

4. Parameters (User)

4.2 Machining Parameters

I-154

# Item

Contents

Setup

range

(unit)

8107 R COMPENSATION

0: In arc cutting mode, the machine moves to the

inside because of a delay in servo response to
a command, making the arc smaller than the
command value.

1: In arc cutting mode, the machine

compensates the movement to the inside
because of a delay in servo response to a
command

0/1

8108 R COMP Select

Specify whether to perform arc radius error
correction over all axes or axis by axis.

0: Perform correction over all axes.
1: Perform correction over axis by axis.
Note: This parameter is effective only when

#8107 R COMPENSATION is 1.

0/1

8109 HOST LINK

Specify whether to enable computer link B instead
of the RS-232C port.

0: Disable computer link B to enable normal

RS-232C communication.

1: Enable computer link B to disable normal

RS-232C communication.

0/1

8110 G71/G72 POCKET

Set the pocket machining if there is a dimple
(pocket) in the rough cutting cycle (G71, G72)
finishing program.

0: Pocket machining OFF
1: Pocket machining ON

0/1

8111 Milling Radius

Select the diameter and radius of the linear axis for
milling (cylindrical/pole coordinate) interpolation.

0: All axes radius command
1: Each axis setting (follows #1019 dia diameter

designated axis)

Note: This parameter is valid only in the milling

(cylindrical/pole coordinate) interpolation
mode.

0/1

8112 DECIMAL PNT-P

0: The decimal point command for G04 address

P is invalidated.

1: The decimal point command for G04 address

P is validated.

0/1

8113 MillingInitG16

0: Plane other than

G16

1: Select G16 plane

8114 MillingInitG19

Designate which plane to use for milling machining
after the power is turned ON or reset.

#8113 #8114

Plane

0 0

G17

plane

0 1

G19

plane

1 0
1 1

G16 plane

Note: This parameter is valid for the G code system

2, 3 (#1037 cmdtyp=3, 4).

0: Plane other than

G19

1: Select G19 plane