Enterasys Networks 1H582-xx User Manual
Security Configuration Command Set
Configuring Port Web Authentication (PWA)
14-67
14.3.5.2 set pwa
Use this command to enable or disable port web authentication.
set pwa {enable | disable}
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to enable port web authentication:
Quiet Period
Amount of time a port will be in the held state after a user
unsuccessfully attempts to log on to the network. Default
value of 60 can be changed using the set pwa quietperiod
command as described in
unsuccessfully attempts to log on to the network. Default
value of 60 can be changed using the set pwa quietperiod
command as described in
MaxReq
Maximum number of log on attempts allowed before
transitioning the port to a held state. Default value of 2 can
be changed using the set pwa maxrequests command as
described in
transitioning the port to a held state. Default value of 2 can
be changed using the set pwa maxrequests command as
described in
NOTE: Port Web Authentication cannot be enabled if either MAC authentication or
EAPOL (802.1X) is enabled. For information on disabling 802.1X, refer to
EAPOL (802.1X) is enabled. For information on disabling 802.1X, refer to
. For information on disabling MAC authentication, refer to
enable | disable
Enables or disables port web authentication.
Matrix>set pwa enable
Table 14-7
show pwa Output Details (Continued)
Output
What It Displays...