TP-LINK TD-W8950ND User Manual
TD-W8950ND
150Mbps Wireless N ADSL2+ Modem Router User Guide
3. Enter
the
Trigger Port Start, Trigger Port End, Open Port Start and Open Port End in the
table, and then select the Trigger protocol and Open protocol, TCP, UDP or All.
4. Click
Save/Apply to enable the settings and then you will see your settings as shown in
)
Note:
If you select the application from the drop-down list, the External Port Start, External Port End,
Internal Port Start, Internal Port End and the Protocol will be added in the table automatically.
Internal Port Start, Internal Port End and the Protocol will be added in the table automatically.
4.4.5.3 DMZ Host
Choose “Advanced Setup”Æ“NAT”Æ“DMZ Host”, you can set up DMZ Host on the screen
(shown in Figure 4-29).
(shown in Figure 4-29).
The DMZ host feature can make a local host be exposed to the Internet for a special-purpose
service, such as online gaming or video conferencing.
service, such as online gaming or video conferencing.
Figure 4-29
To add a new DMZ Host:
You can enter the computer's IP address and then click Save/Apply to activate the DMZ host you
set on this page.
set on this page.
)
Note:
DMZ host forwards all the ports at the same time. Any PC whose port is being forwarded must
have its DHCP client function disabled and should have a new static IP Address assigned to it
because its IP Address may change while using the DHCP function.
have its DHCP client function disabled and should have a new static IP Address assigned to it
because its IP Address may change while using the DHCP function.
4.4.5.4 ALG
Choose “Advanced Setup”Æ“NAT”Æ“ALG”, and then you can configure the basic security in the
screen as shown in Figure 4-29.
screen as shown in Figure 4-29.
38