TP-LINK 1910010885 User Manual
TD-W8970B
300Mbps Wireless N Gigabit ADSL2+ Modem Router (Annex B) User Guide
64
To add a new entry, follow the instructions below.
1. Click
the
Add New button in Figure 4-56, and you will see the screen as shown in Figure
Figure 4-57
2. Enter the following data:
¾
Destination IPv6 Address: The Destination IPv6 Address is the address of the network or
host that you want to assign to a static route.
host that you want to assign to a static route.
¾
Prefix Length: The prefix length of the destination IPv6 address.
¾
Gateway: Here you should type the IPv6 Gateway address correctly, and the option for
Interface will adopt the default IPv6 Gateway address for the IPv6 Static Route.
Interface will adopt the default IPv6 Gateway address for the IPv6 Static Route.
¾
Interface: Select the Interface name from the drop-down list, or else, the default Interface will
be adopted for the IPv6 Static Route.
be adopted for the IPv6 Static Route.
¾
Status: Select Enabled or Disabled from the drop-down list.
3. Click
Save to save your settings.
To modify or delete an existing entry:
1. Find the desired entry in the table.
2. Click
Edit as desired on the Edit column.
Click the Enable/ Disabled Selected button to make selected entries enabled/ disabled.
Click the Delete Selected button to delete selected entries.
4.9.4 RIP Settings
Choose “Route Settings”Æ“RIP Settings”, you can see the RIP (Routing Information Protocol)
screen which allows you to configure the RIP.
screen which allows you to configure the RIP.