TP-LINK 1910010885 User Manual
TD-W8970B
300Mbps Wireless N Gigabit ADSL2+ Modem Router (Annex B) User Guide
65
Figure 4-58
)
Note:
RIP cannot be configured on the WAN Interface which has NAT enabled (such as PPPoE).
4.10 Forwarding
There are four submenus under the Forwarding menu: Virtual Servers, Port Triggering, DMZ
and UPnP. Click any of them, and you will be able to configure the corresponding function.
and UPnP. Click any of them, and you will be able to configure the corresponding function.
4.10.1 Virtual Servers
Choose menu “Forwarding” → “Virtual Servers”, and then you can view and add virtual servers
in the next screen (shown in Figure 4-59). Virtual servers can be used for setting up public
services on your LAN. A virtual server is defined as a service port, and all requests from Internet
to this service port will be redirected to the computer specified by the server IP. Any PC that was
used for a virtual server must have a static or reserved IP address because its IP address may
change when using the DHCP function.
in the next screen (shown in Figure 4-59). Virtual servers can be used for setting up public
services on your LAN. A virtual server is defined as a service port, and all requests from Internet
to this service port will be redirected to the computer specified by the server IP. Any PC that was
used for a virtual server must have a static or reserved IP address because its IP address may
change when using the DHCP function.
Figure 4-59
¾
Service Port: The numbers of External Service Ports. You can enter a service port or a
range of service ports (the format is XXX – YYY; XXX is the Start port and YYY is the End
port).
range of service ports (the format is XXX – YYY; XXX is the Start port and YYY is the End
port).
¾
IP Address: The IP address of the PC running the service application.