Cisco Systems 3130 User Manual
38-41
Cisco Catalyst Blade Switch 3130 for Dell Software Configuration Guide
OL-13270-01
Chapter 38 Configuring IP Unicast Routing
Configuring EIGRP
Use the no forms of these commands to disable the feature or return the setting to the default value.
Configuring EIGRP Interfaces
Other optional EIGRP parameters can be configured on an interface basis.
Beginning in privileged EXEC mode, follow these steps to configure EIGRP interfaces:
Step 6
metric weights tos k1 k2 k3 k4 k5
(Optional) Adjust the EIGRP metric. Although the defaults have
been carefully set to provide excellent operation in most networks,
you can adjust them.
been carefully set to provide excellent operation in most networks,
you can adjust them.
Caution
Setting metrics is complex and is not recommended
without guidance from an experienced network
designer.
without guidance from an experienced network
designer.
Step 7
offset list [access-list number | name] {in | out}
offset [type number]
offset [type number]
(Optional) Apply an offset list to routing metrics to increase
incoming and outgoing metrics to routes learned through EIGRP.
You can limit the offset list with an access list or an interface.
incoming and outgoing metrics to routes learned through EIGRP.
You can limit the offset list with an access list or an interface.
Step 8
no auto-summary
(Optional) Disable automatic summarization of subnet routes into
network-level routes.
network-level routes.
Step 9
ip summary-address eigrp
autonomous-system-number address mask
autonomous-system-number address mask
(Optional) Configure a summary aggregate.
Step 10
end
Return to privileged EXEC mode.
Step 11
show ip protocols
Verify your entries.
Step 12
show ip protocols
Verify your entries.
For NSF awareness, the output shows:
*** IP Routing is NSF aware ***
EIGRP NSF enabled
Step 13
copy running-config startup-config
(Optional) Save your entries in the configuration file.
Command
Purpose
Command
Purpose
Step 1
configure terminal
Enter global configuration mode.
Step 2
interface interface-id
Enter interface configuration mode, and specify the Layer 3
interface to configure.
interface to configure.
Step 3
ip bandwidth-percent eigrp percent
(Optional) Configure the percentage of bandwidth that can
be used by EIGRP on an interface. The default is 50 percent.
be used by EIGRP on an interface. The default is 50 percent.
Step 4
ip summary-address eigrp
autonomous-system-number address mask
autonomous-system-number address mask
(Optional) Configure a summary aggregate address for a
specified interface (not usually necessary if auto-summary is
enabled).
specified interface (not usually necessary if auto-summary is
enabled).