Fujitsu RX300 S2 User Manual

Page of 8
2
4
Checking location before installing the server
For details on installing the rack, refer to the "Installation 
Guide for the RACK" and the manual provided with the 
rack.
n
Conditions
When installing this server avoid the following areas.
- Humid, dusty, or oily areas
- Poorly ventilated areas
- Areas close to fire or other sources of heat
- Areas close to water
- Areas close to direct sunlight or near heating appli
  ances
- Areas with a temperature of below 10°C or above 35°C
- Areas with humidity of less than 20% or more than 80%
- Salty areas
- Areas where corrosive gas is generated
- Areas where cables become trip hazards
- Areas where strong magnetic fields are generated, 
  such as near TVs and speakers
- Areas where the device is not stable and could tip 
  over and hurt somebody
n
Installing the server to the rack
Make sure to contact an office listed in the "Contact In-
formation" before attempting to install or remove a server 
from the rack.
1
Open both the front and rear doors of 
the rack. 
2
Check where to attach the slide rail 
and rack nuts
Attach the slide rail to the front and rear brackets.
Attach the rack nuts to the front brackets.
��
���������������������������
��������������������������
����������������
������������������������������
������������������������������
���������������
�������������
��
����������������
������������������������������
������������������������������
����������������������
3
Remove the inner rail from the slide 
rail
Press down the lock in the center of the inner rail 
to remove.
�������������������
����������
����������
����
����������������
4
Attach the inner rail to the server.
����������������������
���������������
���������������������������
���������������������������
Left and right inner rails are different.
Check the letter at the lock part for correct installation.
5
Remove the flathead screws fixing the 
slide rail bracket, and attach binding 
head screws.
Two on the front: Tightly fasten where the flathead   
screws were used.
Two on the rear: Loosely fasten at the location in 
the following figure.
����������������������
���������������
�������
��������������������
����������������������
�����������������������������
���������������������������������
������
����������������������������������
- In dusty area, dust will quickly stick to the front and 
  backside of the server. Since this can cause failure, 
  changing the installation place is recommended.
- Be sure to secure racks and cannect stabilizers to prevent 
  the device tipping over.