Fujitsu RX300 S2 User Manual

4

Turning on the power and setting hardware

Normally, hardware settings are not required to be changed from the default. 

However, in the following cases, start each utility and check/change hardware settings.

������������

 "Chapter 8 Hardware Configuration / Utilities"

l

Change the settings in the following cases:

- When changing the drive to start the server
- When installed/removed optional devices
- When performing remote installation

1

Power on the peripheral devices, such 

as the display.

2

Turn on the power and insert 

ServerStart CD-ROM immediately.

1. Press the power switch on the front of the 

server.

2. Press the CD-ROM eject button, and insert 

ServerStart CD-ROM.

3

Set the hardware.

If no hardware settings are performed, skip to the 

next step when a message to insert the ServerStart 

floppy disk is displayed.

l

BIOS Setup utility

1. When the "<F2> BIOS Setup / <F12> 

Boot Menu" message appears at the server 

startup (during POST), press the [F2] key.

2. Check/change the settings.
3. Select "Save Changes & Exit" from the 

Exit menu and press the [Enter] key.

For the use of Linux distribution with diskless type, 

refer to the Fujitsu PRIMERGY website (http://

primergy.fujitsu.com).

- Print the "Configuration Sheets" - "Configuration sheet" in the PRIMERGY Document & Tool CD (Disc 2) and 

then write down the hardware configuration and the setting value of BIOS setup utility.

������������

�������
������������

����������
������������