Lucent Technologies 555-233-115 User Manual

Page of 502
DEFINITY Enterprise Communications Server Release 8.2
Upgrades and Additions for R8r  
555-233-115  
Issue 1
April 2000
Adding or Removing Cabinet Hardware 
6-109
Add a Switch Node Carrier (High or Critical Reliability) 
6
Save Translations
1. Log in at the management terminal.
2. If the system is high- or critical-reliability, type status spe and press 
Enter 
to verify that the standby SPE is refreshed and that the standby disk is in 
service.
3. Type save translation [spe-a or both] disk and press 
Enter
. This 
command instructs the system to take all translation information in 
memory and write it to the disk(s).
4. If the system contains a TN750/B Announcement circuit pack, type 
display announcements and press 
Enter
.
5. If administered recorded announcements are listed, type list 
configuration software-version and press 
Enter
. Check screen 2 to find 
out when the announcements were last saved. Save the current 
announcements by typing save announcements disk and pressing 
Enter
.
6. Type backup disk [spe-a or both] and press 
Enter
. This instructs the 
system to backup the current information on disk to the system tape(s).
7. Update backup tape(s), if required.
Shut Down DEFINITY LAN Gateway System
If a DEFINITY LAN Gateway system resides in the control cabinet to be 
upgraded, prepare to shut down the DEFINITY LAN Gateway assembly and 
allow the disk to completely spin down. 
!
CAUTION:
Make sure that you save the system parameters if you plan to reuse the 
current system.
!
WARNING:
Neglecting to shut down a DEFINITY LAN Gateway assembly before 
powering down the system cabinet where it resides can damage the LAN 
Gateway disk.
1. Log onto the DEFINITY LAN Gateway. See the 
DEFINITY Communications 
System Generic 3 Installation, Administration and Maintenance of 
CallVisor ASAI over the DEFINITY LAN Gateway.
2. When the main menu appears, select 
Maintenance.
3. Select 
Reset System from the Maintenance menu.
4. Select 
Shutdown from the Reset System menu.
5. Unseat the LAN Gateway assembly from its backplane connectors.