Lucent Technologies 555-233-115 User Manual
DEFINITY Enterprise Communications Server Release 8.2
Upgrades and Additions for R8r
Upgrades and Additions for R8r
555-233-115
Issue 1
April 2000
G3vs with Intel 386 or Risc Processor to R8r
4-7
Remove the Present System
4
Remove the Present System
■
If the equipment room is large enough to allow the Release 8r cabinet to
be installed while the present system is in service, skip to
be installed while the present system is in service, skip to
. Return to this section when finished.
■
If the present system must be removed to make room for the Release 8r
cabinet, perform the following.
cabinet, perform the following.
Save Translations and Announcements
1. Log in at the management terminal on the present system.
2. Type save translation and press
Enter
. This command instructs the system
to write all translation information from memory to the translation card.
3. Check for translation errors before proceeding with the upgrade. If errors
are detected, refer to
to correct the problem. Do not continue
with the upgrade until the errors are corrected.
4. If the system contains a TN750/B Announcement circuit pack, type
display announcements and press
Enter
.
NOTE:
The TN750C Announcement circuit pack contains non-volatile
memory and does not require backup.
memory and does not require backup.
5. If administered recorded announcements are listed, type save
announcements and press
Enter
.
6. Remove the translation card and install the backup translation card.
Check Link Status
1. Type display communication-interface links and press
Enter
. Write down
all enabled links.
2. Type status link
number and press
Enter
. Repeat this step for all links.
3. Write down which links are in service.