Mitsubishi lt-3280 Owner's Manual

Through NetCommand, you can automatically start and 

stop recordings and send signals from one playback 
device to a recording device.  Recordings can be made 
on recordable devices connected to the media center.  

The media center can convert digital channels and 

IEEE 1394 device signals to analog signals that can be 
recorded on NetCommand compatible analog VHS and 
S-VHS  VCRs.  

You can schedule the recording to take place at a later 

time and program the recording duration for a minimum 
of 30 minutes and a maximum of 6 hours (in 30 minute 
increments).  The default is 1 hour.  During the recording, 
the media center can be powered Off.  If the media 
center is powered On, it must be tuned to the source 
that is being recorded.

Can be used when viewing Antenna 1 or 2, an IEEE 1394 
device or a non-recording traditional device. 

To initiate recording now:

1.  Press REC (record) on the TV remote.

2. Press DEVICE on the remote control to move to the 

Source Device section. 

3. Press ADJUST   or   to select the source device you 

will record from.  If a source is not displayed, it is not 
available as a recording source.

4. Press ENTER to confirm selection and return to the 

“Record to” section.    

5. In the “Record to” section, review the destination 

device and duration.  Use  ADJUST 

 or 

 to change 

if necessary.

6. Press REC a second time to initiate recording.

To initiate a time-delayed recording:

1.  Press REC (record) on the TV remote.

2. Press DEVICE on the remote control to move to the 

Source Device section. 

3. Press ADJUST     

 

 to select the source device 

you will record from.

4.  Press ENTER to confirm your source device selection 

and move to the Record to section.

5. Press ADJUST    or   to select the Record to device, 

duration time, start time (press ENTER after selecting 

hour, minutes and AM or PM to set the time) and 

day.  For devices that can select channels, select the 
channel.

6.  Select Add and press ENTER to add the recording 

to the record list.  If your selection is successful, a 
confirmation message will be displayed.  If you pick 
overlapping times, day(s), or destination devices, you 
will see a message stating there is a conflict.

7.  To exit, press HOME on the TV remote after all 

recordings have been added.